We are a professional manufacturer of rough-terrain forklifts. We have the capability to develop part-time 4WD models, and we have researched and prototyped various 4WD drivetrain solutions.
We built two different part-time 4WD rough-terrain forklift prototypes for internal durability testing. One of them adopts the widely known rear axle design with 80-degree steering angle.
The test conditions simulate typical off-site working scenarios: heavy load, muddy ground and slope operations where wheel slip occurs frequently.
During the test, we observed the following issues on these two prototypes:

Part-time 4WD rough terrain forklift prototype 1 rear axle for durability test

80 degree steering angle rear axle of part-time 4WD rough terrain forklift prototype 2

Transfer case for 2WD and 4WD switching on part-time 4WD rough terrain forklift

Transfer case for 2WD and 4WD switching on part-time 4WD rough terrain forklift-2
- The engagement of 4WD relies heavily on the driver’s operation skill. If the driver engages 4WD only after wheels start spinning on mud or slope, sudden impact force will damage the differential gears and drive shafts.
- The part-time 4WD engages rigidly. When turning or driving on surfaces with uneven grip, speed difference between front and rear axles creates heavy internal stress. This leads to high fatigue risk for axles and universal joints.
- It is not suitable for conditions requiring frequent switching between 2WD and 4WD. Frequent engagement brings repeated shock loads, accelerates wear of transmission parts and increases failure rate.
- Limitation of rear axle load-bearing structure: The rear axle matched with this part-time 4WD is not a rigid load-bearing design. When working under heavy load on uneven and sloped terrain, there are potential load-bearing risks, which may cause axle deformation and abnormal bearing wear over time.
Please note: These issues were found on our own two test prototypes under our test cycles. It does not mean all part-time 4WD forklifts from other manufacturers will have the same problems, as design, material and manufacturing quality vary greatly.

Complete unit photo of part-time 4WD rough terrain forklift prototype 1

Complete unit of part-time 4WD rough terrain forklift prototype 2 with 80° steering axle
Based on our quality standard, the part-time 4WD solution cannot meet our reliability requirements for continuous heavy-duty off-road work.
Important note: We are able to produce part-time 4WD forklifts and we have finished prototype development. However, after professional evaluation for off-road applications, we conclude it is not suitable for mass production. Therefore we do not actively promote this drivetrain and do not recommend it to our customers.
Our main product is full-time 4WD rough-terrain forklift. Power is distributed to front and rear axles continuously, without rigid shock during engagement. No manual 2WD/4WD switching is required. It is equipped with rigid load-bearing rear axle, performs much more steadily on slippery, sloped and rough ground, with lower impact on transmission components.